The Only Guide for How to Install Vinyl Siding—the Home Exterior That's Hot Again

Then, measure from the eave to the bottom of the existing siding. If this distance is divisible by 8 inchesthe completed width of a piece of sidingyou're in luck. The utility trim you'll set up under the eave will accept the top edge of the last full-width row of siding. When it comes to Dutch lap siding, which looks like 2 courses of siding in each single panel, you'll have two chances: at 4- and 8-inch periods.

If you have to cut the leading row of siding, then use J-channel on top rather of utility trim. To keep this last cut row from collapsing versus your house, nail a 3-inch strip of 1/2-inch plywood versus the J-channel to hold it out. When you have actually figured out the very best height for the metal starter strip, mark this position on the walls and snap a referral chalkline around the whole house.

Vinyl Siding Cost: Here's What You're Really Paying For

Vinyl Siding Installation Action # 6: Siding the Walls PM Next, nail strips of 1/2-inch rigid-foam sheathing to both sides of the corners and nail the corner trim over these strips. Vinyl Siding Installation Step # 7: Siding the Walls PM Follow by nailing window and door trim around any exterior doors and sheath the very first few feet of the walls with insulation.

This article explains how to install vinyl siding so that it looks good and  doesn't leakIncluded is … - Vinyl siding installation, Vinyl siding, Installing  siding

Measure for the first piece and trim it to length, making sure that it's 1/2-inch shorter than the distance in between vertical trimpieces, as measured from the within surface areas of the channels.  Research It Here  Siding Setup Action # 8: Siding the Walls PM Snap each length of siding in location, so that its bottom lip hooks under the starter strip.

The smart Trick of Pricing Guide: How Much Does Vinyl Siding Cost? - LawnStarter That Nobody is Discussing

Be sure to center the nails in their slots to accommodate growth. Vinyl Siding Setup Step # 9: Siding the Walls PM When signing up with two lengths of siding, lap one length over the other around 1 inch. When it comes to which direction to lap, consider which angle will get the closer examination.

Installing Vinyl Siding over Wood Siding? Siding contractors answer inside.

Vinyl Siding Setup Step # 10: Dealing with Obstructions PM If your house has a deck, it's most likely to be suspended from a wall and covering the bottom of the existing siding. In this case, you'll need to keep the starter-strip height on both sides of the deck and cut the siding to fit above the deck.